MOTORRAD BREMSSCHEIBEN EBC MD6282D

EBC HPSR brake disc, rigid version. MADE IN UK.

The aim of the development is to improve the braking performance compared to the original brake disc. EBC uses low carbon HPSR steel, which has an 18% higher coefficient of friction. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected by a 3 micron thick zinc layer, which abrades itself in the area of ​​the brake pad contact zone during braking. Only in this area can more easily rust form during prolonged life.

The brake discs are drilled in Vogelschwingendesign to get along with as few holes as possible while optimizing cleaning of the brake disc of rainwater and brake dust. The fewer holes are fitted, the better the wet braking performance and the lower the wear.

- Brake ring machined from forged HPSR low carbon steel.

- Therefore, no distortion of the brake disc even at maximum load.

- No vitrification of the braking surface, friction coefficient remains constant.

- Drilled brake surface with optimized hole pattern.

- Galvanized for protection against corrosion.

- Lowest manufacturing tolerances.

- For best braking performance, EBC recommends EBC Double-H Sinter brake pads.

- Independent design.