REPRO TEILE 37070200 Motorcycle grips

Grips 'Antique', for Vespa 125 VNB3-6/150 VB1/VBA/VBB 125 VNB3-6/150 VB1/VBA/VBB/VGLA-B/T3-T4/GS VS2-5/160GS, red, Ø 22 mm, l 125 mm, as accessory A high-end reproduction of the original PIAGGIO bar-grips to the exact original dimensions. This is also true for the colour and the shape. They come with a design similar to the earlier shield-shaped PIAGGIO emblems. They are available in grey, light-grey, beige/grey (earlier model colours) and black. The later models carry the hexagonal PIAGGIO emblem. Furthermore we also have grips in premium quality on offer. These are produced using high quality and UV-stable rubber that does not harden or lose its colour. With their 'Antic' intricate diamond-shaped design, including the earlier PIAGGIO-emblem they equal the originals in quality and design down to the final detail. Note: Please make sure of the correct measurements when ordering your new grips. (Circumference and length of both throttle and gear grips, they are sometimes different !) Grips with identical dimensions are interchangeable. The earlier grips are just a little too short, so leaving a noticeable gap between the inner grip and the handlebar cover of later largeframe models. This can be solved by shortening the handlebar tubes themselves. SIP-TIP: The easiest way to remove your old handlebar grips is to carefully cut them open along their whole length using a carpet knife or similar. To soften the new grips enough to push them over the bar ends we recommend you leave them in very hot water for 10 minutes beforehand. Please remember to use gloves or a thick piece of cloth to stop your fingers getting burnt.