DISQUE FREIN MOTO EBC MD1184

Brake discs EBC. MADE IN UK.

The aim of the development is to improve the braking behavior compared to the original brake disc. EBC uses HPSR steel with a low carbon content, which has an 18% higher coefficient of friction. This steel is much more resistant to rust than cast steel. In addition, the entire surface is protected with a 3 micron thick zinc layer, which grinds off in the area of the brake pad contact zone when braking. It is only in this area that slight rust film can form with a longer service life.

The brake discs are drilled in the bird's swing design in order to get by with as few holes as possible and at the same time optimized cleaning of the brake disc from rainwater and brake dust. The fewer holes are drilled, the better the wet braking behavior and the less wear.

- Rigid brake disc.

- Made from rolled HPSR steel with low carbon content.

- Braking surface drilled with optimized hole pattern.

- Radially ground.

- Galvanized to protect against corrosion.

- EBC recommends EBC Organic brake pads or for sporty drivers EBC Double-H sintered brake pads.

- Independent design.